To the best of my knowledge this is not implemented (yet?) in the WCCPv2
patch for Squid by Visolve.
Regards
Henrik
On Fri, 19 Aug 2005, Valton Hashani wrote:
> Hi,
> I sent the same content of this email to a squid users mailing list but I
> got no answer. Can you help?
> ---------------------------
> The Squid is working fine with WCCPv2 but as far as I can see in squid conf
> can only one wccp2_router directive defined. I need squid to communicate
> with multiple routers. In case I use wccp2_router 225.25.25.25 to
> communicate with group of routers, routers can see the squid but cannot form
> service group.
> This is a message I get from the Cisco Router: "WCCP-EVNT:S00: Here_I_Am
> packet from 80.x.x.x w/bad rcv_id 00000000"
>
> I have attached an email that I found in squid archive dating Tue, 02 Sep
> 2003
> so I just want to know if squid can communicate with multiple routers using
> WCCPv2 (multicast or unicast)?
>
> Thank you in advance,
> Valton
>
>
Received on Mon Aug 22 2005 - 12:48:09 MDT
This archive was generated by hypermail pre-2.1.9 : Wed Aug 31 2005 - 12:00:06 MDT