Squid configuration directive sleep_after_fork

Available in: v7   v6   v5   v4   3.5   3.4   3.3   3.2   2.7   3.1   3.0   2.6  

For older versions than v4 see the linked pages above

Configuration Details:

Option Name:sleep_after_fork
Replaces:
Requires:
Default Value:sleep_after_fork 0
Suggested Config: 


	When this is set to a non-zero value, the main Squid process
	sleeps the specified number of microseconds after a fork()
	system call. This sleep may help the situation where your
	system reports fork() failures due to lack of (virtual)
	memory. Note, however, if you have a lot of child
	processes, these sleep delays will add up and your
	Squid will not service requests for some amount of time
	until all the child processes have been started.
 

Back

 

Introduction

Documentation

Support

Miscellaneous

Web Site Translations

Mirrors