Squid configuration directive cache_swap_log
Available in: 2.6
This directive is not available in the v7 version of Squid.
This directive is not available in the v6 version of Squid.
This directive is not available in the v5 version of Squid.
This directive is not available in the v4 version of Squid.
For older versions than v4 see the linked pages above
Configuration Details:
| Option Name: | cache_swap_log |
|---|---|
| Replaced By: | cache_swap_state |
| Requires: | |
| Default Value: | none |
| Suggested Config: |
|
Location for the cache "swap.state" file. This log file holds
the metadata of objects saved on disk. It is used to rebuild
the cache during startup. Normally this file resides in each
'cache_dir' directory, but you may specify an alternate
pathname here. Note you must give a full filename, not just
a directory. Since this is the index for the whole object
list you CANNOT periodically rotate it!
If %s can be used in the file name it will be replaced with a
a representation of the cache_dir name where each / is replaced
with '.'. This is needed to allow adding/removing cache_dir
lines when cache_swap_log is being used.
If have more than one 'cache_dir', and %s is not used in the name
these swap logs will have names such as:
cache_swap_log.00
cache_swap_log.01
cache_swap_log.02
The numbered extension (which is added automatically)
corresponds to the order of the 'cache_dir' lines in this
configuration file. If you change the order of the 'cache_dir'
lines in this file, these log files will NOT correspond to
the correct 'cache_dir' entry (unless you manually rename
them). We recommend you do NOT use this option. It is
better to keep these log files in each 'cache_dir' directory.
|
|
| Index | Alphabetical Index |